CO2 cartridge assembly is done by removing the cover from the handle, turning the pressure screw, inserting a new cartridge and tighten the screws,

How to take care of you airgun powered by Co2

This method has been tested in a wide range of conditions, including water, dust, pressure and heat, but does not include corrosion. It also removes the need for a screwdriver to remove the handle.

The cover is held in place by two screws. The cover is removed by removing the cover screw in the same manner. After removing the cover, the barrel and magazine are cleaned off with a clean tissue, then cleaned with water.

The magazine is cleaned using a soft cotton swab. Cleaning also removes residue on the cover.

The gun is cleaned using a tissue.

Cleaning also removes residue on the cover. The cleaning is finished by wiping on a clean tissue with a soft tissue, which is then wiped off with a dry towel. The dry tissue is removed and the new tissue is removed.

The barrel is cleaned with another cotton swab. Cleaning may cause the new steel to come loose and break. The barrel is then cleaned to remove the rust.

The stock is cleaned using cotton swabs. The new stainless steel stock is ready for the next stage of manufacturing. Before firing the magazine, clean the stock to remove any rust. Once the stock has a good luster, the gun can be cleaned again and the stock placed under a hot water bath.

After cleaning, the new stock can be fitted on the magazine.

Comments